Skip to main content

Redstone sensor

Introduction​

The Redstone Sensor will be activated when a redstone signal powers it. There is a condition mod present for other components to use, click here for more details.

You cannot configure this component itself, it is mostly useful for the condition mod.

How to place a Redstone Sensor​

  • Open Lasers-Enigma main shortcut bar by typing the /lasers command.
  • Aim for the block on which you want to place the component. This can be on the floor, ceiling, or wall. Then right-click with the "place component" button in hand.
  • Select the Redstone Sensor.
  • Now that the component is placed, the Redstone Sensor edition shortcut bar will open and you will be able to edit the component.

Interactions​

Redstone interaction​

The Redstone Sensor will be activated when powered by redstone signal.

ℹī¸ When the puzzle resets (the last player leaves the area), the Redstone Sensor is forced back to its deactivated state, even if a redstone signal is still powering it. It is re-evaluated against the current signal as soon as the area becomes active again. This guarantees a clean state for the next run and prevents a leftover signal from keeping a condition met across resets.

Other component interactions​

Any other component has not direct interaction with the Redstone Sensor but, it can be used as a condition mod, you can check more details here.

Known issues​

No bugs have been reported for this component yet.

See our issue board for more information.